4
www.Observint.com
© 2014 Observint Technologies. All rights reserved.
8.
Use the camera record mode Wizard as follows:
a.
On the Cameras line at the top of the window, open the drop-down list and select the camera you want to configure for
recording.
b.
Click the
Start Recording
box to check it.
c.
Select one of the recording modes: either
Normal
or
Motion Detection
mode.
5.
In the date and time setup window, click the field you want to change, then use the drop-down list or setup aid to select the
appropriate values. Click
Next
to confirm your settings or
Cancel
to discard them and open the network setup Wizard window.
6.
In the
Network
setup Wizard window, click the field value you want to change, then use the pop-up aid to enter a new value. By
default, the NVR uses DHCP (Dynamic Host Configuration Processor) to acquire compatible (dynamic, changeable) network settings
from a network DHCP server.
Generally, it is preferable to setup the NVR with a fixed network settings, if possible, to assure the NVR has an unchanging IP address
for remote logins. To enable fixed network settings, uncheck the
Enable DHCP
box, then edit the appropriate fields to change the
settings. Consult with your network administrator to determine the best network settings for your NVR. When finished, click
Next
.
7.
Click
Next
after you configured the network parameters. The HDD management Wizard window will open. If a new NVR is shipped
with a pre-configured HDD, nothing needs to be done in this window. If you installed an HDD or replaced the HDD, select (check the
box for) the HDD, then click
Init
to setup the disk for the NVR.
NOTE
:
Init
will erase all data from the disk. When the initialization is
complete, click
Next
to continue.
