1
www.observint.com
ALI-NS4114R 4MP Vari-focal IP Bullet Camera Quick Installation Guide
ALI-NS4114R_CQ
180410
Safety cable
Conduit
adapter
Sealing plug
for interface
wiring (5)
Captive screws
connect to
adapter plate (3)
Side inlet
cover
Junction box (inside view)
Hook for safety cable
Interface terminals
for alarms, audio,
LAN, power
Adjustment
bracket lock
screw
Back of camera (junction box removed)
What’s in the box
Your camera includes the items shown below.
Mounting hardware
Insertion tool
Junction box screws
Security L-wrench
Conduit adapter
BNC video
maintenance
cable
Step 1. Route wiring to the camera
Interface cables can be routed into the camera either through the adapter plate (through the mounting
surface or through a gang box), through the side inlet of the junction box, or through conduit.
NOTE
When selecting a mounting location for the camera
• Make sure that there are no reflective surfaces near to the camera lens. IR light from the camera may
bounce back onto the lens causing reflections.
• Determine how wiring is routed into the camera. The cable can be routed through conduit
(a threaded conduit adapter is provided), through the mounting surface and access hole in the
mounting plate, or through the side inlet.
See photos above. The camera includes connectors for the following:
•
Ethernet
(required): The Ethernet drop cable can connect to a LAN extension cable from a
switch or Network Video Recorder. The camera can be powered across the LAN using power over
Ethernet (PoE) injection. See the Specifications section at the end of this document for power
requirements.
•
12 Vdc power input
(optional if PoE powered, required if not): If powering the camera
with a long power extension cable, refer to the tables at the end of this guide for wire gauge
requirements. Voltage input at the camera can be within the range 12 Vdc ± 25%.
This document guides you through the basic steps to install and configure the ALI-NS4114R network
vari-focal bullet camera. This camera features:
•
1/2.5” 2560 × 1440 pixel Progressive Scan CMOS sensor
•
2.8 ~ 12 mm motorized vari-focal lens
•
Low light 0.008 lux color minimum illumination
•
H.265, H.265+, H.264+, H.264 video compression
•
120 dB Wide Dynamic Range
•
Back light compensation (BLC) / 3D dynamic noise reduction (DNR)
•
IP67 weatherproof, IK10 vandalproof rated
•
4 behavior analyses and face detection
For more information, refer to these documents - available from your equipment vendor:
•
ALIBI™ Tools Utility Installation and User Manual
•
ALIBI™ Witness 2.0 r3 App for Android or iOS Quick Start Guide
•
ALIBI™ IP Camera Firmware Version 5.4 User Manual
(or later) provided at:
AlibiSecurity.com/resources
Lens
Sun shield
Camera body
Maintenance panel
Adjustment
bracket
Junction box
Junction box screw (4)
Adapter plate
Screw stud for
junction box (3)
Hole for surface
or gang box
cable routing
Holes (2) for
single-gang box
mounting (#2)
Holes (4) for
surface mounting
or double-gang
box (#1)
Adapter plate
Side inlet
cover
Side inlet with
conduit adapter
Sealing plug
for interface wiring (5)
Sealing plug
for LAN/PoE cable
Ground terminal
Junction box (adapter plate side)
