Installation
Telephone Connection
Two RJ12 telephone jacks are provided on the rear of the 4100
AuxBox. To connect to the telephone cable pair:
1.
Disconnect your telephone line cord from the wall jack
and connect to either one of the RJ12 telephone jacks on
the 4100 AuxBox. Using the supplied telephone line cord,
connect the second RJ12 telephone jack on the AuxBox to
your telephone wall jack.
2.
Ensure that your digital telephone is operational. This may
take a few minutes depending on your telephone system.
OR -
1.
The 4100 may be installed in a bridging configuration
using either RJ12 jack. Maximum recommended cord
length is 15 feet.
The TDM light on the front panel will show whether the telephone
connection was successful. This light will be winking twice for
Norstar / BCM, or once for Meridian 1 or Succession. Allow
approximately eight seconds for this to begin.
Lift the telephone handset (or go off-hook with the speakerphone
or headset) to turn on the “In-Use” light on the front panel of the
4100 AuxBox. This indicates that the unit is working properly.
10
4100 AuxBox
