ALGE-Timing Windspeed WS2, Руководство пользователя, Страница: 9 / 11

Windspeed WS2
Page 9
4 Mounting of the anemometer WS2
Dismantle the interlock (1) of the tripod-legs and pull
them out totally. Now interlock the tripod-legs.
The tripod-middle-part (2) must be completely insert-
ed
Screw the provided intermediate-piece (3) on the tri-
pod-middle-part and put the anemometer WIND-
SPEED
WS2 (4) afterwards on the top.
Remove the protection rings (5) and connect the pro-
vided cable.
If the mounting is correctly, the distance between
ground and middle of wind catcher shall be approxi-
mately 1,22m.
!! Attention – The arrow, located on the upside of
the anemometer, must always show into the run-
ning direction !!
5 Operation of the anemometer WINDSPEED WS2
The handling of the program is very easy. As soon as all components are connected,
you just have to chose the desired wind-measuring-type.
F0 Normal
Measures the wind-speed continuously. This mode is used before the run or
sprint starts.
F1 100 m / 200 m / 75 m / 80 m H
Measures the average speed for 10 seconds. This mode is used for all sprint-
runs from 75m on (except 100m hurdles or 110m hurdles).
F2 110 m H / 100 m H
Measures the average speed for 13 seconds. This mode is used for 100m
hurdles or 110m hurdles.
F3 Jump / < 75m
Measures the average speed for 5 seconds. This mode is used for all sprint-
runs under 75m.
If the anemometer is connected to the ALGE Photofinish-system OPTIc, a manual
handling is not applicable. The software of OPTIc adopt the handling automatically.
1
5
4
3
2