Alfresco ALXE series, Инструкция по уходу и эксплуатации

Страница: 13 / 32

13
PUSH TO
IGNITE
PUSH & TURN TO “HI”
Keep your face away from the grill as far as possible and pass a lit,
long stem match through the notch in the grill rack to the ports of
the burner you are trying to light. When attempting to light a burner
with a match, ensure that the correct burner control knob is used.
Position the match near the burner ports. Push and turn the control
knob to “HI”. Repeat procedure on each burner if necessary. If the
burner does not light in 4 seconds turn the knob OFF, wait 5
minutes and try again. If the burner will not light after several
attempts see page 25: Troubleshooting.
To assure that an IR burner is lit, very carefully
place your hand 8-10 inches away from the
burner surface. If you do not feel the heat of
the burner, shut off control knob, wait five
minutes, and attempt to relight.
BUTTON SYMBOLS AND LOCATIONS:
SMOKER BURNER LIGHTING:
To light the smoker burner, remove the smoker tray completely. Push and turn the smoker control knob
to the “HI” position and immediately depress the proper igniter button for your model.
(See
BUTTON SYMBOLS AND LOCATIONS above).
SIDE BURNER LIGHTING (MODELS ALXE-56 & 56 SZ):
When lighting, always keep your face and body as far away as possible from the burners.
FRONT BURNER: Push and turn the side burner right hand control knob to the “HI” position and
immediately depress the right hand igniter button. You’ll hear a snapping sound from spark that will be
provided to both side burners. It is necessary to keep the igniter button depressed until the burner is lit.
REAR BURNER: Repeat the same operation as explained on the front burner but using the side burner
left hand control knob this time.
IGNITER BUTTON SWITCH
(on TOP)
LIGHT FIXTURES SWITCH
(on MIDDLE)
ROTISSERIE SWITCH
(on BOTTOM)
CAUTION
IN SUNNY ENVIRONMENTS,
THE FLAME FROM AN IR
BURNER MAY BE IMPOSSIBLE
TO SEE.