ALFRA 22413.110, Инструкция по эксплуатации

Страница: 7 / 16

ADDITIONAL SAFETY RULES OF
METAL CUTTING SAW
CAREFULLY READ THE FOLLOWING SAFETY WARNINGS PRIOR TO CONNECTING THE
METAL CUTTING SAW TO POWER.
1. Must keep the safety device in the fixed position, and work according to the order. Never wedging
or binding the safety device below and must use it. Before using the metal cutting saw every time,
must ascertain the safety device below is working. Never operating forcedly if the blade can not be
covered completely.
Caution: It probably bends the safety device below when the circular saw fall to the ground, and it can
be used again till check result is OK after repairing.
2. The blade should be kept clean and sharp. Breakdown and rebound can be lowered to the
minimum limitation with the blade sharp.
3. Danger: The hand must depart from the sawing area when tool works. No touch blade when blade
is rotating, no put the work-piece in, either. No take the process-work-piece sawed by hand when
blade is still rotating.
Caution: The blade will slide a period of time after turning off the Switch.
4. Adjustment. Before sawing, ascertain the adjustment of saw depth is right.
5. Must select the right blade. Use the suitable saw blade within the range shown on nameplate.
6. Guide cord should be apart from sawing place and be fixed when sawing, and ensure it can not be
twined by work-piece when sawing. The tool must be held steadily when sawing, and use the
appropriate work-piece to support, and put the guide cord far away from the work-piece.
7. Do not use cutting oil while cutting.
8. Do not use blades which are deformed or cracked.
9. Always use safety glasses. Wear safety glasses. Everyday eyeglasses only have impact
resistant lenses; they are not safety glasses.
10. To avoid possible hearing damage, wear ear plugs when using power tool.
ASSEMBLY AND ADJUSTMENT INSTRUCTIONS
WARNING:
For your own safety, never connect the plug to a power source outlet until all assembly steps are
complete and you have read and understood the safety and operating instructions. The safety
cover is attached to the saw for your protection. Should the safety cover become damaged, do not
use the saw until damaged cover has been replaced. If the safety cover becomes dirty, or chip
adheres to it. Clean the safety cover carefully with a damp cloth.
Installing a New Saw Blade
WARNING: To prevent an accident or personal injury, always turn off the trigger switch and
disconnect the power plug from the receptacle before removing or installing a blade.Only use
blades designed for metal cutting saw.Not touse any abrasive wheels Fitting of alternative purpose
or different sizes blades could void the warranty. Checkregularly that the blade is flat, Sharp and