150 TURBO / 150
Ultima modifica/ Last Update: 18/03/2008 Rev0 pagina 11 di 15
PROBLEM
CASE
SOLUTION
The welding is non opti-
mal.
Spattering occurs during welding.
Make sure welding polarity is correct, the
earth clamp is fixed correctly.
When welding the pro-
tection devices of the
line set off.
Make sure the welding current does not re-
quire greater power than the one supplied
by the line.
Decrease the welding current.
The machine always
welds at maximum cur-
rent.
The Front Panel is damaged.
The Power Board is damaged.
The shunt wires are damaged or not cor-
rectly inserted in the 6-pin connector.
The doubler board is damaged.
Switch off the machine and disconnect the
plug:
!
The Front Panel must be replaced.
!
The Power Board must be replaced.
!
Connect the cables or if damaged replace
them (picture 1).
!
The doubler board must be replaced.
