alfaplam ALFA TERM 20 PELET, Инструкция пользователя

Страница: 26 / 31

16
14.3. 5. MANUAL LOADIN G ME N U
This menu allows manual pellets loading when the cooker is commissioned for the first time.
To perform this operation, the system needs to be in OFF state.
14.3. 6. TIME A ND DATE MENU
This menu allows you to set the exact time and date.
By pressing the P4 and P6 buttons, the hours, minutes, years, months and days are set.
The change mode is entered by pressing the P3 button, while P4 and P6 buttons are used for changing the value.
Changes are saved by pressing the P3 button and then one can leave the menu by pressing the P1 button.
14.3. 7. REMOTE CON TROL ME N U
This menu allows you to activate or deactivate the remote control - Remote Control SYTX. Remote control is not
provided as factory setting.
14.3. 8. LANGUAGE SELECTIO N M ENU
This menu allows you to change the language on the LCD display.
14.3. 9. DISPLAY MENU
Menu Description
Set contrast Menu for setting contrast on the LCD display
Set Minimum Light Menu for setting brightness on the LCD displeja
14.3.9.1 SETTING CONTRAST
Via P4 and P6 buttons contrast is increased or decreased.
By pressing the P3 button, the changes are saved and one can exit the menu.
Via P1 button one can exit the menu without saving the changes.
14.3.9.2 SET MINIMUM LIGHT
Via P4 and P6 buttons brightness is increased or decreased (min 0, max 20).
By pressing the P3 button, the changes are saved and one can exit the menu.
Via P1 button one can exit the menu without saving the changes.
14.3. 10. SYS TEM MENU
This menu allows access to technical settings. Access is password protected and allowed only to authorized technical staff.
14.4. COOKER IGNITION AND FUNCTIONAL CONDITIONS
The cooker is switched on by pressing the P2 button for more than 3 seconds. After that you can find the following
functional conditions of the cooker:
Check Up
In the check up stage, the initial check of the input signals of the cooker and the correctness of the probes is performed. At
this stage, the flue gas fan runs at the maximum speed and the auger and igniter are switched off. The check up stage takes a
few seconds and after a successful check, the ignition stage starts.