2
6.
INSTALLING
The installer must follow the following instructions in order to properly install the cooker:
- Plug in the cooker into the socket with grounding. (Figure 9)
- Set the cooker switch to position 1. (Figure 10)
- Do not allow the presence of children and pets near the cooker.
- Use only pellets as fuel.
- Inform all users of possible risks and dangers and teach them how to handle the cooker.
- If the cooker is placed on a wooden floor, then it is advisable to isolate the stand on which it is positioned.
The cooker works with a combustion chamber with a sub-pressure. So make sure the smoke extractor is thermally sealed.
When commissioning for the first time, ensure ventilation of the room, as the applied corrosion protection may produce an
unpleasant odor and create smoke for a short time. That is normal and it stops after a short while.
Figure 9
Figure 10
6.1.
SAFETY MEASURES FOR MAINTENANCE PERSONNEL
Maintenance installers, in addition to having to comply with all security measures, must:
- always use safety devices and personal protective equipment,
- disconnect the power supply before they start to work,
- always use an adequate tool,
- before starting any work on the cooker, make sure that it has cooled down and that the ash is cold. In particular, make sure
that the handles are cooled before you touch them.
- NEVER TURN THE COOKER ON if any of the security devices are defective, incorrectly set or not working.
- Do not perform any type of modification, for whatever reason, other than those allowed and recommended by the
manufacturer itself.
- Always use genuine spare parts. Never wait for the components to wear out before replacing them. Replacement of the
worn-out part, or component of the cooker before it brakes, contributes to preventing the occurrence of damage due to sudden
failure, which can cause serious consequences for people and/or property.
- Clean the firebox before turning the cooker on.
- Make sure there is no condensation. If condensation occurs, this indicates the water generated from the smoke cooling
process.
We recommend you to find possible causes in order to establish normal and correct operation of the cooker.
6.2.
SAFETY MEASURES FOR USERS
The location of installation of the cooker must be prepared in accordance with local, national and European regulations.
This cooker is manufactured to burn fuel made of pressed wood (pellets diameter 6 mm, length up to 30 mm, maximum
humidity 8-9%).
ATTENTION: High temperatures are generated on external surfaces of the cooker during operation.
Therefore, it is important to pay attention to the following during operation of the cooker:
- do not approach and touch the glass on the firebox and oven door, there is a DANGER OF BURNS,
- do not approach and touch the smoke extraction pipe, there is a DANGER OF BURNS,
- do not perform any cleaning,
- do not open the firebox door when the cooker is operating properly, only when the chamber is sealed,
- do not remove ashes when the cooker is in operation,
- children and pets must stay away from the cooker,
- OBSERVE ALL ADVICES GIVEN IN THESE INSTRUCTIONS.
