Maintenance and repair
New seal install
To place the new valve seal, place the seal at
the entrance of the opening. The conical side
needs to be orientated toward the interior.
With the help of a 7mm drill mounted upside
down in a drill press (used as a press), press
the new seal in its emplacement with caution
To reassemble, make sure to re-screw the valve
by hand firmly as well as the lever to close the
valve.
Then you can re-screw the M3x8 Allen screw on
the side of the metallic part with a 1.5 mm key.
Warning : the screw need to remain 1mm
out from the metallic surface (can be
measured with slidding calliper)
Once all the internal parts reassembled, you can replace the back cover of the
Tyrecontrol as well as the batteries and batteries cover with the srews previously
unscrewed
Warning
During disasemble or reasemble of parts, make sure to not damage any mechanical or
electronical parts.
For any questions or hesitations, do not hesitate to contact Alfano S.A. :
Rue de l'Industrie, 3B
B-1400 Nivelles (Belgique)
Phone: +32(0)67 410 846
Email : [email protected]
Содержание A1950
Страница 1: ...Manual EN A1950...
