5 Maintenance
Take care not to damage shaft surfaces, in particular where bearings and lipseals will be located
Ensure all fastenings are tightened to the torque settings as shown in Technical Data (See chapter 6 Technical data)
5.6 Single Flushed Seal - All Models
3205-0048
80
71
73
72
82
87
88
83
89
85
90
91
82
81
3205-0080
85
90
91
A
Asssseem
mbbllyy
Check that all parts are accounted for and ensure no parts are damaged. Seal faces are brittle, and care must be taken not to
chip these components during fitting of the seal. Ensure seal faces are clean throughout the fitment. If a need to be cleaned,
use acetone or similar solvent sprayed onto lint free tissue.
Equipment to be used: Acetone, compatible lubricant and lint free tissues
S
Stteepp 11
Lightly lubricate screw clamping profile elastomer (80) with suitable lubricant compatible with the application and fit to the
rotary holder (71).
S
Stteepp 22
Place plastic washer (82) in rotary holder (71) aligning the slots in the washer (82) with the pins fitted in the rotary holder bore (71).
S
Stteepp 33
Lightly lubricate elastomer (82) with suitable lubricant and fit into rotary holder (71) groove.
41
CONTACT CSI FOR MORE INFORMATION | CSIDESIGNS.COM | [email protected] | 417.831.1411
