Alfa Laval GJ PF, Инструкция по эксплуатации

Страница: 33 / 46

6 Maintenance
Read the instructions carefully.
The items refer to the parts list and service kits section.
6.5 Reassembly
General notes
All parts must be cleaned thoroughly before reassembling. Any deposits remaining on the parts can cause difficult
disassembly the next time the Alfa Laval GJ needs to be serviced. Also, it may cause misalignment of parts and the potential
for premature failure.
Unless otherwise stated, apply a dab of a PTFE-based anti-seize compound to all threads when reassembling; this will
prevent galling of threads and ease any future disassembly.
To ease installation of all O-rings, they should be lubricated prior to reassembly. Lithium-based grease is acceptable, for Viton
®
O-rings, however, silicone based lubricant must be used for EP O-rings. Do NOT grease the clutch O-ring (29).
Refer to the illustrations in Appendix C for clarification during reassembly.
Gear train
Step 1
1. Insert the gearbox screws (31) through the gearhead (14).
2. Push the input shaft through the input shaft lower bearing
housing (36).
3. While installing the lower bearing housing onto the (14), ensure
the input pinion meshes properly with the top layer of gears.
4. Using a flat-head screwdriver, screw the (31) into the lower
bearing housing.
31
14
33.1
36
34
4125-0030
33