Alf ISIV-01, Руководство пользователя

Страница: 20 / 28

6-7
Assembling the stand fan to the base
1. Take out the base nut and tube nut.
2. Slide the decorative cover down to the bottom of iron tube, and then draw out plating
tube and tighten the tube nut.
3. Fix the iron tube to the base properly and tighten the base nut.
4. Insert the fan body to the plating tube and tighten the set screw.
Assembly of the Fan
Assembling the rear guard
1. Take out the rear guard mounting nut by turning it anti-clockwise.
2. Insert the rear guard into the motor, matching the 2 rods on the front side of the motor
(direct the handle of the fan upwards) to the 2 holes of the rear guard.
3. Fasten the rear guard tightly by turning the guard mounting nut clockwise.
Assembling the fan blade
1. Insert the blade to the motor shaft and ensure the pin enters the blade slot.
2. Tighten the blade using the blade cap turning it anti-clockwise in the direction
“TIGHT” arrow on it.
Note: Proper assembly of the blade is of great importance. Otherwise, the blade will be
loose and it will damage the fan.
Assembling the front guard
1. Fix the front guard with the logo in the upright position. Make sure they are connected
from the upper side.
2. Take the front guard with the guard ring and set in the groove and fix it tight
with a screwdriver.
Note: Do not operate the fan without assembling the guards properly and tightly.