After carrying out connections as indicated into the corresponding paragraph, the device is ready.
Use is really simple: when you connect the battery, the device turns automatically on and supplies the receiver; keep the magnetic key
close to the sensor for at least two seconds in order to turn the device off and on.
NOTE: every time you bring the key close to the sensor, the light indicator starts to flash quickly.
Place the magnetic key close to the red circle as indicated by the red arrow for turning the device on/off.
ATTENTION: the ESC micro Switch MGN in off state has a current consumption of about 300 mA in 30 days
ATTENTION: the light indicator doesn't show the battery status of charge, but the activation of the electronic switch.
USAGE
PICTURE 2
Magnete
Hall-effect
sensor
Keep the magnetic key close to
the sensor for at least two seconds
for turning ON / turning OFF the
device.
Magnetic key
Operating voltage:
from 5V to 9
Allowed battery:
4-5cells
Output voltage:
NOT STABILIZED
Dropout voltage regulator:
35mV@ 6A
Max load:
6A continuous (15A peak)
Dimensions:
26
Weight:
6g including cables
Working temperature:
-10 up to +60 °C
Nixx, 2s Li.Poli, 2s LiFe
Current drain Switch ON:
6,5mA
Current drain Switch OFF:
300mA every 1 months
x12x4mm
These specifications may be changed without advance notice.
This is not a toy.
Pay close attention to the following points, as the non
observance of them can destroy the product, nullify your
warranty and lead to property damages or personal severe
injuries!
- Never leave the product unattended while it is switched on, in
use or connected with a power supply. If a defect occurs, it
could set fire to the product or to the surroundings.
- Avoid incorrect connections or connections with reversed
polarity.
- All wires and connections have to be well insulated. Short-
circuits might destroy the product.
- Never allow this product or other electronic components to
come into contact with water, oil, fuels or other conductor liquids,
as these could contain minerals, which are harmful for electronic
circuits. If this happens, stop the use of your product immediately
and let it dry carefully.
- Always wire up all the parts of the equipment carefully. If any of
the connections loosens, due to vibrations, you might damage
your device.
- Never cut off or modify the original plugs
- Never change the polarity of the receiver connectors
- Do not open the product and never solder on the PCB
At the end of its life cycle this product is subject to special
waste disposal and it cannot be disposed with urban
waste
SPECIFICATIONS
WASTE DISPOSAL
WARNING
