User manual mod.
ALESSI
PHONE
6
ENGLISH
User manual mod.
ALESSI
PHONE
7
7 Installation
• Phase 1: connect the base
1) Identify the connectors for the plug-plug telephone cable (
) and
for the power supply cable (
), as from the figures below.
2) Insert the jack of the power supply cable in the appropriate seat on
the back of the base (
) then insert the electric power supply into a
wall mains socket located in the vicinity of the base.
3) Insert the telephone cord jack in the appropriate seat on the back
of the base (
) then directly insert the other end of the cable into the
wall socket or using a suitable telephone socket (not supplied with
the equipment and not shown in the picture).
NOTE:
The telephone is able to operate likewise, with both perform-
ing the connection with the telephone line using a telephone socket
(not supplied with the equipment and not shown in the picture), and
using the sole plug-to-plug telephone cable directly inserted into a
modular jack (wall socket); with both such connection modalities, the
telephone will always be connected in parallel to the line.
• Phase 2: insert the battery into the handset
Remove the white plastic shell from the back side of the handset,
exerting a light force on the opening hole with both hands, as illus-
trated in the picture.
Insert the battery as illustrated in the picture, taking care that the po-
larities indicated on the battery’s label are visible and looking upwards.
Then close the cordless. In order to verify the correct insertion of the
battery, switch on the cordless by keeping the
key pressed for 1
second. Select the desired language to be used for menu’s visualiza-
tion and press OK. It’s also possible to change the menu language at
any moment as described at Chapter 17 (section “Language of the
menus”) of this manual.
For your safety and for the correct operation of the cordless use only
the rechargeable battery provided with the product or a battery of the
same type. Refer also to the security regulations reported in the para-
graph “Security notes and care of the product” in this manual.
• Phase 3: place the handset on the base for charging
Switch on the handset by keeping the
key pressed for 1 second.
Place the cordless on its base to keep the battery charged: an acous-
tic tone will confirm the correct positioning of the cordless on the base
and then the charging of the battery will start. The first charging will
require 16 hours.
8 Security notes and care of the product
• Always use
the original rechargeable battery or a battery of the
same
type
.
• Pay much attention that the battery is correctly inserted in its slot by
respecting the correct polarities
• Do not attempt to open / damage the battery.
• Do not throw the battery into the fire: it could explode.
• Perform the first charging for at least 16 hours. Later a recharge
time of 8 hours will be sufficient.
• Do not expose the battery to temperatures lower than: -10°C or
higher than +50°C during operation; only recharge the battery at a
temperature in between 0°C and + 40°C.
• In case the telephone is unused for a prolonged time, it is recommended
to take off the battery from the battery vane.
• Use only
the supplier provided with the equipment
.
• The equipment could interfere with electro-medical devices. Observe then
the indications located in the premises (e.g. surgeries, hospitals, etc.).
• Do not keep the handset in bathrooms or in the shower. The handset
and the base are not protected against water sprays.
Connectors located in the telephone jack
located under the base:
1. not connected
2. not connected
3.
a
4.
b
5. not connected
6. not connected
6
5
4
3
2
1
▼
Use exclusively the original power supplier equipped with the product.
The power supplier must always be inserted into the mains socket. If
another telephone cable is purchased in a shop, make sure that the
connections are identical to the one of the supplied cable.
