Alert-it Care Systems P139AA, Инструкция по эксплуатации

Страница: 6 / 24

UH1075_P139_Instructions_English.ppp 29/08/2016 16:01:45 Page 2 of 22
P139 GUARDIAN MONITOR INSTRUCTIONS
IMPORTANT
Please read these instructions carefully before using the equipment and keep readily available for reference
purposes.
It is not intended for this equipment to be used in diagnosis of medical conditions or for the measurement of any
physiological processes. If the user is considered to be at high risk it should not be used without medical advice and
support.
The equipment can, when used correctly and in accordance with the instructions, be used to give warnings of
symptoms that may be related to particular conditions. The equipment, for a number of reasons, cannot be guaranteed
detect the symptoms being monitored and is not a substitute for direct supervision.
If there is ever any cause for concern with the performance of the equipment the supplier should be contacted.
DISPLAY & CONTROLS
Overview
A liquid crystal display screen with back lighting and a touch sensitive keypad is provided in order to indicate and
adjust, as required, the functions and the status of the system.
In the event of an alarm condition a highly visible red alarm light will flash on the top of the monitor (through this can
be disabled if it cause a nuisance) There are a number of screen displays, which provide details of each function and
allow adjustment of the various settings. Pressing the 'menu' button advances the screen display in sequence and the
settings can be adjusted by pressing the ‘INCREASE’ or ‘DECREASE’ buttons. By pressing the 'menu' button
repeatedly, the screen displays can be scrolled in sequence until the one required is observed. BACK reverses the
menu scrolling, stopping at the “Monitoring” screen, it also functions as the ‘ALARM RESET’ button when an alarm
condition is active.
The 'menu' button has the additional functions of a ‘POWER ON’ switch when the monitor is turned off
Continuously pressing a button has the same effect as repeated pressing.
If no buttons are pressed for longer than 30 seconds and no alarms have been activated the backlight turns off and
the screen will show the normal “monitoring” display.
When sound or motion is detected this is indicated by display symbols on the screen situated above the sound and
motion arrows. This facilitates testing and validating the monitor.
INCREASE
Set Snooze
DECREASE
& reset Snooze
& reset Max/Min
BACK
Reset alarms
Open menu
Power on
Sensor Indicators
)*#