www.aleratec.com
2
Installing the Hardware
1. Remove the DVD/CD RoboRacer SA from the box. Connect the power
cord to the machine. Attach the appropriate power adapter if necessary (for
280112EUR). Connect the power cord into an appropriate power source. Place
the RoboRacer SA on a level surface.
2. Slide the bin holder into the slot on the left side of the RoboRacer SA case and
place a disc output bin into the bin holder. There are two output bins included
(50 disc capacity, 100 disc capacity). Make sure to keep the output bins that
come with the 280112. Although similar to a normal disc media cover, the Disc
Output Bins are for specific use with the RoboRacer SA. When installing, make
sure that the flanges on the bin are touching the lip of the bin holder. If the bin
is not pushed down as far as it can go, the edge of the bin could interfere with
the disc output. To use the 100 disc bin, the DVD/CD RoboRacer SA should be
placed at the edge of a desk or table. Make sure that the bin does not touch the
edge of the desk or table surface.
3. Take the clear plastic disc guide rods and place them into the 4 holes in the
top of the unit. To load the discs into the input bin, take one disc and place it
horizontally level in the input bin. Now you can load the rest of the discs. All of
the discs need to be level with the sides of the stack straight.
4. Same the box and packaging material for return shipment should your unit
require service.
Note:
Choose a Good Location
1. Allow adequate clearance for moving parts.
2. When placing the duplicator on the side/edge of a tabletop ensure
that all four foot pads are in complete contact with the surface of
the table.
3. Do not place near heat sources such as radiators or air ducts, or
in a place subject to direct sunlight, excessive dust, mechanical
vibration or shock.
4. Good care will help assure maximum product life. Improper
operating environment and misuse may void the warranty.
5. Turn the duplicator off and leave unplugged when not in use.
