GENERAL SAFETY INSTRUCTIONS
1. DO NOT STAND ON THIS STOOL. DO NOT USE
STOOL AS A STEP LADDER.
2. Use this product only for seating one person at a time.
3. Do not use this stool unless all screws are firmly secured.
4. At least every 4 months, check all screws are firmly
secured.
5. If parts are missing, damaged, broken or worn, stop use of
this product until repairs are made using factory authorized
parts.
6. This stool is designed and intended for users up to 300 lbs.
Use by users above 300 lbs. is not recommended since it
could weaken the stool construction and potentially cause
injury.
7. FAILURE TO FOLLOW THESE WARNINGS COULD
RESULT IN SERIOUS INJURY.
8. Warranty may be void is stool is used while damaged.
Immediately call 1-800-733-4000 and report any problems.
ERGONOMIC FEATURES
To maximize the ergonomic benefits of the Sit/Stand, it is
essential to understand how adjustments effect your
posture.
CAUTION:
Make sure you grasp seat handle before lifting
front of seat and adjusting seat height to prevent pinching
of your fingers.
1. Lift seat from under front center of seat to unlock it. Seat
assembly can now slide freely up and down the support
column. Seat assembly is adjustable in height from 22
3
⁄
4
″
to 32
3
⁄
4
″. Position seat assembly at a comfortable height in
relation to your body size and the height of the work
surface. Seat should be high enough for you to rest your
weight on while maintaining a slight bend in the knees.
Grasp seat handle to maintain desired seat height. Push
front of seat down completely to lock seat height.
2. Raise handle under right side of seat to tilt seat into
position. Always tilt seat forward to accommodate a
leaning posture. Lower handle to lock seat at desired
angle.
3. Padded seat is ergonomically contoured and textured for
breathability. Position your weight on center of the seat.
Allow seat to swivel with your body when reaching from
side to side.
MAINTENANCE
Clean polyurethane seat with soap and water. To repair
small cuts in polyurethane, apply a few drops of quick
drying glue in the cut and press sides together until glue
sets. Periodically check faasteners for tightness. Replace
pads if worn.
Raise handle under right
side of seat and tilt seat to
desired angle.
Lower handle to lock seat at
desired angle.
Grasp front of seat with one
hand and handle at back of
seat with other hand. Lift
seat from under front center
of seat to unlock it. Position
seat assembly at desired
height.
Grasp seat handle to main-
tain desired seat height.
Push front of seat down
completely to lock seat
height.
