ASSEMBLY INSTRUCTIONS
Read these instructions before starting; follow assembly
procedures carefully.
1. Base base
1
right-side up on a flat surface or workbench.
Insert support column
2
into groove at base. Bumper
stops must be towards rear of sit stand. Align the holes in
support column with holes in base. Insert bolts (4.4) from
outside and fasten down from inside with fiber hex nuts
(4.5) to secure base. Slide shrouds down column to cover
top of base. Shroud should be positioned over hex nuts.
2. Place base on the floor. Slide seat assembly
3
onto
support column. Push down front of seat to lock seat
position.
3. Mount handle (4.3) to back of seat assembly. Align holes
in handle with holes in back of seat assembly. Secure
handle with two screws (4.6).
4. Grooves in top of right and left sleeves (4.1) should be
aligned with tabs of handle cover (4.2). Be sure the seat is
facing the correct direction
before
inserting the handle and
handle cover.
WARNING:
It is important the tabs in handle engage in
column to ensure that handle locks in place.
Insert handle, handle cover and sleeves (4.2) onto top of
support column. Tap handle into place.
Sit/Stand Series
Adjustable height stool
ALE-SS600
PARTS LIST
1 PC.
1 PC.
1 PC.
Parts bag components
4.1
4.2
4.3
4.4
4.5
4.6
1
4
2
3
ASSEMBLY
STEP 1
STEP 2
STEP 3
STEP 4
Slide shrouds down to cover
hex nuts and top of base.
Stool assembled
