3(5)
To fill the gun with a filler pump
A bulk loader nipple will need to be installed on the grease gun head cap
(not included, see grease chapter in the Alentec&Orion catalogue).
Replace the pipe plug in the head cap with the bulk loader nipple. Engage the follower rod
with the follower by rotating the follower handle. Insert the gun filler nipple into the
filler pump socket. Operate the filler pump to fill the container. When the follower rod groove is
exposed, the grease tube is filled. The follower rod will be extended approximately 8 inches (20 cm).
Disengage the follower rod from the follower by rotating the follower handle.
Push the follower rod into the grease tube.
Priming
In most cases the grease gun will be primed by pulling the trigger switch several times in short bursts while
pressing the air bleeder valve. This will remove possible air in the pumping mechanism.
If grease fails to appear, the head assembly must be bled. This is done by unscrewing the barrel a few threads,
and while applying slight pressure on the follower rod, pull the trigger switch in short bursts. The grease should
now start flowing.
Inspection, maintenance and cleaning
WARNING! Make sure the switch is in the “off“ position, battery is removed from the grease gun and that the
charger is unplugged from its electrical outlet before performing any maintenance or cleaning.
BEFORE EACH USE: Check the general condition of the grease gun. Check for broken parts, leaking battery,
damaged hose and any other condition that may affect its safe operation. If abnormal noise or vibration occurs,
have the problem corrected before further use.
Do not use damaged equipment.
DAILY: Use a soft, dry cloth to remove all grease and dirt from the exterior of the grease gun. Do not use
solvents to clean the grease gun.
Spare parts/accessories
1355009
12V battery charger
1355010
18V NiMh battery pack
1355011
Outlet hose
1355012
Grease tube including gasket
1355013
230V battery charger
