SER 9911-A
High-Pressure Portable Pump
Revision (05-01)
4
Alemite Corporation
Assembly
NOTE: Refer to Figure 2 for component
identification on assembly procedures.
Hand Cart Assembly
1. Remove Bolt (26), Lock Washer (27) and Handle
Assembly (28) from Fork Assembly (23)
[as shipped].
2. Position the Handle Assembly on top of the Fork
Assembly.
3. Screw the Bolt with Lock Washer into the Handle
Assembly from the bottom of the Fork Assembly.
• Tighten the Bolt securely.
Follower Plate (Not Included)
4. Loosen Thumb Screws (10) that secure Cover
Assembly (9) to Container (12).
5. Remove the Cover and Pump Assembly from the
Container.
6. Install the 35-pound container into Spacer Ring (11).
NOTE: When bulk filling Container (12),
remove the Spacer Ring and fill the Con-
tainer with product. Do not allow air to mix
with the product during the filling process.
Pump may lose prime.
Changes Since Last Printing
Changed Handle from 305376-2 to 318414
7. Place the follower plate onto the top of the product.
See Table 2.
• With a wobbling motion, eliminate any air that may
be trapped underneath the follower plate. Force the
product through the hole in the center of the plate.
8. Guide the pump tube into the follower plate and fit the
Cover onto Container (12).
9. Secure the Cover to the Container with Thumb
Screws (10).
10. Test/Prime the Pump assembly.
• Refer to Service Guide SER 9911/9950 for details.
Accessories
Accessory items available for these pumps are listed in
Table 2.
Part Number
Description
337665
Follower Plate (for 35-pound container)
338801
Follower Plate (for 70-pound container)
Table 2
High-Pressure Portable Pump Accessories
