Alemite 8702 Series, Руководство по обслуживанию

Страница: 7 / 12

High-Pressure Hydraulic Pump
SER 8702
Alemite LLC 7 Revision (1-10)
Figure 4 Pump Tubes 337384-H1, -D1, and -E1 - Section View
8. Install Pin (30).
9. Screw Rod (10) into Coupling (11)
until the pin holes align.
• Install Pin (9).
10. Screw Coupling (7) [center hole
first] onto the Rod until the pin
holes align.
• Install additional Pin (9).
11. Secure the hydraulic motor
assembly in a soft-jaw vise.
12. Screw the Coupling assembly onto
the hydraulic motor rod until the
pin holes align.
• Install Pin (8).
13. Install and seat Seal (21) [lips first]
into the bottom of Retainer (20).
See Figure 2.
14. Install and seat Bearing (22) into
the bottom of the Retainer.
15. Install Gasket (23) onto the top of
Extension (24).
16. Screw the Extension (Gasket end
first) into the bottom of the
Retainer.
• Do not tighten at this time.
17. Install Gasket (6) into the top of
the Retainer.
18. Install and seat Bearing (19) [small
diameter first] and additional
Gasket (6) into the top of the
Retainer.
19. Screw Tube (18) into the top of the
Retainer.
• Do not tighten at this time.
20. Install and seat Gasket (6) into
Adapter (5).
I M P O R TA N T: I f a
primer is used with Loc-
tite 222, the curing time
is greatly reduced.
Refer to Figure 2 Parts List
for Parts Identification
Pump Tube (Outer Components)