Alarm
Setting & turning on the wake-up alarm:
1. press and hold the
ALARM SET
button for
2 seconds
2.
use +/- to set the hours and briefly press the
ALARM SET
button
3.
use +/- to set the minutes and briefly press the
ALARM SET
button, the alarm time is now saved
(and is also activated immediately)
Switching on/off:
Briefly press 2x the
ALARM SET
button. When
the wake-up alarm is currently enabled, “ ” will be
shown; if “ ” is not illuminated, the alarm is disabled.
Operation:
• As soon as the set time is reached, the alarm will
sound for up to 120 seconds.
• Press the
ALARM SET
button to stop the alarm
signal earlier or press the
SNOOZE/ LIGHT
but-
ton to enable the snooze function; the wake-up
alarm will then sound again after 5 minutes.
• The alarm is repeated daily.
Temperature display
Use the
°C / °F
switch at the rear of the indoor unit
to display the temperature in degrees Celsius or in
degrees Fahrenheit.
The
symbol is followed by the indoor temperature.
Behind that the outdoor unit is shown from out-
door unit 1.
Use the
CH
button at the rear of the indoor unit to
display the temperature from outdoor unit 2 or 3 or
press and hold the
CH
for 2 seconds to automatically
start scrolling through all channels. Briefly press the
CH
button to stop this scan.
See also chapter ‘
Expansion
’.
Max/min temperature:
Briefly press the
MEM
button to check the maximum
temperature measured, press the
MEM
button again
for the minimum temperature.
Press and hold the
MEM
button for 3 seconds to
delete the MAX and MIN values. Also after replacing
the batteries of pressing the
RESET
button, the MAX
and MIN values are deleted.
Ice alarm:
As soon as the outdoor temperature falls within a
range of +3°C and -2°C, the
symbol starts flash
-
ing in the display.
Weather forecast:
The WS-2200 can predict the weather for the
following 12 to 24 hours based on the changes in air
pressure and shows this forecast using the following
icons:
Remarks:
• the accuracy of a forecast based on air pressure
is 70% to 75%; please keep in mind that a correct
display of the weather forecast is not guaranteed.
• the prediction is based on the coming 12 to 24
hours and does not necessarily represent the cur-
rent weather conditions.
• the ‘Sunny’ forecast shown at night means an
open weather type.
• the ‘Rainy’ prediction during winter, usually means
snow.
Expansion:
You can register up to 3 outdoor units to the indoor
unit to have the temperature measured at 3 different
locations (e.g. in your greenhouse, pet room, differ-
ent bedrooms, etc.). You can order additional outdoor
via the Alecto customer service at phone number 073
6411 355 (Netherlands) or 03 238 5666 (Belgium) or
via the internet at www.alecto.info
Registering additional outdoor units:
1. slide down the battery cover at the rear of the
new outdoor unit and insert 2 AA 1.5V batter-
ies according to the markings inside the battery
compartment.
2. just above the batteries at the rear of the outdoor
unit, slide the ‘
CH
’ channel switch to position 2 or
position 3.
3. slide the battery cover back onto the outdoor unit.
4.
now repeatedly and briefly press the
CH
at the
rear of the indoor unit until or illuminates
(depending on whether you’ve selected ‘
CH-2
’ or
‘
CH-3
’ in the outdoor unit) and then briefly press
the
SENSOR
button.
5. the indoor unit will now start searching for the out-
door unit and as soon as the units find each other,
the temperature will be shown on the display of
the indoor unit.
Reset/System error:
If the WS-2200 shows a possible error, you may have
to reset the indoor and outdoor unit.
1. use a sharp object to press the reset button at the
rear of the indoor unit.
2. use a sharp object to press the reset button at
the rear of the outdoor unit (for this, you’ll need to
briefly remove the battery cover from the outdoor
unit).
The indoor and outdoor units will then be reset and a
new pairing scan will start. After several seconds, you
can continue using the WS-2200.
If you still have no connection or sound, please
contact the customer service of Alecto via the phone
number 073 6411 355 (Netherlands) or 03 238 5666
(Belgium) or via internet www.alecto.nl
Specifications:
Indoor unit:
measurement range: -40°C ~ 70°C (-40°F ~ 158°F)
recommended operating temperature:
0°C ~ 45°C (32°F ~ 113°F)
resolution:
0.1°C / 0.1°F
DCF receiver:
DCF-77
power supply:
2x 1.5V battery, size AA
battery lifespan:
1 year
dimensions: 84(W)x141(H)x47(D)mm
weight:
186g (batt incl.)
amount of outdoor units to register: max 3
Outdoor unit:
measurement range: -40°C ~ 70°C (-40°F ~ 158°F)
recommended operating temperature:
-20°C ~ 55°C (-4°F ~ 131°F)
resolution:
0,1°C / 0,1°F
power supply:
2x 1,5V battery, size AA (*)
battery lifespan:
1 year
dimensions: 65(W)x100(H)x35(D)mm
weight:
75g (batt incl.)
*: for long-term use at temperatures below 0°C,
we recommend using Lithium batteries which you
can order via the Alecto customer service at phone
number 073 6411 355 (Netherlands) or 03 238 5666
(Belgium) or via the internet at www.alecto.nl.
Radio:
transmission frequency: 433MHz
channels: 3
reception interval:
60-64sec.
range: 50m
Symbol :
Only
illuminates:
no outdoor unit is registered
on this channel.
flashing:
the indoor unit is searching
for the outdoor unit.
remains lit:
the indoor unit is connected
to the outdoor unit
Declaration of confirmity
The declaration of conformity is
available on the website
WWW.ALECTO.NL
Environment:
At the end of its lifespan, this product should not be
discarded as normal domestic waste, but is must be
taken to a collection point for the recycling of electric
and electronic equipment.
Don’t throw away exhausted batteries, take
them to your local depot for small chemical
waste.
5
6
7
8
Sunny
partly
cloudy
cloudy
rainy
ver1.2
Service
Help
Service
Help
WWW.ALECTO.NL
NL 073 6411 355
(Lokaal tarief)
BE 03 238 5666
(Lokaal tarief)
(Tarif local)
DE 0180 503 0085
Lokale Festnetzkosten
Hesdo, Australiëlaan 1
5232 BB, ‘s-Hertogenbosch
The Netherlands
WWW.ALECTO.NL
NL 073 6411 355
BE 03 238 5666
DE 0180 503 0085
Hesdo, Australiëlaan 1, 5232 BB,
‘s-Hertogenbosch,
The Netherlands
(Lokaal tarief)
(Tarif local)
(Lokaal tarief)
(Lokale Festnetzkosten)
v2.1
