4
Parent Unit
Basic Steps to Install
1.
Connect the output plug of the mains adapter to the DC socket at
the back of the baby unit and the mains adapter to the wall mains
supply.
2.
Plug the charger adaptor for the Parent Unit into the mains power
socket.
3.
Remove the battery door on the Parent Unit by lifting the battery
door outward.
4.
Insert 2 x AA rechargeable batteries, observing their polarities, into
the battery compartment on the Parent Unit.
5.
Replace the battery door on the Parent Unit.
6.
Place the Parent unit on the charger to charge. The red Led on the
charger will turn on
7.
Let the batteries charge for a full 16 hours before using for first time
installation.
Note: The baby unit also works on battery power. You can insert 4 x
1.5V AA Alkaline batteries in the battery compartment on the
Baby Unit. In case of power interruption, the baby unit continues
to work on battery power. If the baby unit is on battery power,
Battery is displayed, together with the battery icon and current
temperature, on idle mode.
CAUTION
Use only the mains adaptor and charger adaptor supplied with
baby monitor. Incorrect adaptor type can cause damage to the
unit.
Input: 230 VAC 50 Hz
Output: 6 VDC 500 mA
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN
INCORRECT TYPE. Never use non-rechargeable batteries; use
recommended type supplied with this product. NiMH batteries
must be disposed of in accordance with applicable waste disposal
regulations.