ALE TC Series, Руководство оператора, Страница: 12 / 18

Design • Print • Trace
07/07/2011
The TC72-H has been specially built to be used with the
ALE
BOBET7X ink and the TC54-H
and TC18-H have been specially built to be used with the
ALE
BOB ink. Using any other
fluid is likely to severely damage the hydraulic system.
●
Fitting a bottle of ink into the reservoir:
Using a craft knife (or a sharp blade), cut the round raised plastic dome on the top of
the ink bottle cap (Fig. 14). Turn the bottle up-side down and push into the reservoir
(Fig. 15).
●
Switch the controller on. From this moment, the LCD screen will run through the
start up procedure. After a few seconds, the controller will emit some beeps. This is
an automatic set up, so there is nothing to do until the screen shows “
Print msg : 01
”
and
“***no text***
”. The default language is English on all new machines.
●
To change to the language required, press and then press the arrow down
until you select the language required, for example “ Langue, Français”. Enter by
pushing . The screen will display “
Impr. Mess: 01” “Pas de message”.
Please report
to the controller documentation for more information.
●
The controller needs to be adjusted to the print-head. To check this, press until
you reach “
Install settings
”and press . LCD says “
head config
”. If your
configuration is not already selected, press the arrow down until you reach your
configuration.
For the TC72 : If the TC72 has an 80pL print-engine the configuration to select is
" 1xT72mm 80pL ". Otherwise the configuration to select is " 1xT72mm ".
For the TC54 the configuration to select is "
1xT54mm
", and for the TC18
"1xT18mm
"
●
Press to validate.
Then the ink system needs to be purged of air.
TC series print-heads Operator Manual 8
Fig. 14: Cutting the plastic cap of the ink bottle
Fig. 15: fitting a bottle