AFTER SALES SUPPORT
1300 922 271
MODEL NUMBER: GL-CC 36 Li, 02/14
16
•
Never immerse the unit in water or other liquids
in order to clean it.
9.2 Carbon brushes
•
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important!
The carbon brushes should not be
replaced by anyone but a qualified electrician.
9.3 Maintenance
9.3.1 Replacing the saw chain and cutter rail
•
The cutter rail needs to be replaced if the guide
groove of the cutter rail is worn; the nose
sprocket in the cutter rail is damaged or worn.
•
Proceed as described in the section “Assembly
of the cutter rail and the saw chain”.
9.3.2 Checking the automatic chain
lubrication
•
You should check the operation of the
automatic chain lubrication system on a regular
basis in order to guard against overheating and
the associated damage to the cutter rail and the
saw chain. To do this, point the tip of the cutter
rail towards a smooth surface (board, section of
a cut tree) and allow the chainsaw to run.
•
If an increasing oil trace becomes evident
during this process then the automatic chain
lubrication system is working properly. If no
clear oil trace is evident then please refer to the
corresponding instructions in
•
“Troubleshooting”. If the information contained
there still fails to remedy the situation then
please contact our service department on 1300
922 271.
Caution: Do not actually touch the surface with
the tip of the cutter rail when performing this
test. Keep a safe distance (approx. 20cm).
9.3.3 Sharpening the saw chain
•
Effective working with the chainsaw is only
possible if the saw chain is in good condition
and sharp. This also reduces the risk of kickback.
•
The saw chain can be re-sharpened by any
dealer. Do not attempt to sharpen the saw chain
yourself unless you have the necessary special
tools and experience.
9.4 Ordering replacement parts
Please call our customer service centre on 1300 922
271 and provide the following information on all
orders for spare parts:
•
Model/type of the equipment
•
Article number of the equipment
•
ID number of the equipment
•
Spare part number of the required spare part
Storage and Transport
10
Store the equipment and accessories out of children’s
reach in a dark and dry place at above freezing
temperature. The ideal storage temperature is
between 0-40°C for the cordless tool and charger and
between 10 and 20°C for the Li-Ion battery.
Store the electric tool in its original packaging.
Disposal and Recycling
11
The equipment is supplied in packaging to prevent
it from being damaged in transit. The raw materials
in this packaging can be reused or recycled. The
equipment and its accessories are made of various
types of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your local council.
