VII. CLEANING
Neither hose down nor use running water to clean the mower.
• Always keep the machine clean. For cleaning, use a brush or cloth, but no cleaning
agents or solvents.
• After mowing, remove any plant remains stuck to the wheels and the blade area.
Caution! Risk of injury! Sharp blades - wear gloves
• Rub the blades with an oil rag or spray them with a metal maintenance spray.
• Due to the special cutting geometry, the blades cannot be re-sharpened. If neces-
sary, the blade cylinder (Fig.3/Pos.21) and sub-blade must therefore be replaced as a
set. Have a specialist workshop carry out the installation of the blade cylinder (Fig.3/
Pos.21). -
Blades are available from After Sales Support!
VIII. MAINTENANCE
Adjust the cutting clearance (Fig. 1)
The sub-blade must be adjusted if the grass is no longer being cut evenly and cleanly.
1. Take the key (2) from the key holder (3).
2. Push a piece of normal paper between the cutting blade (19) and the sub-blade
(20).
3. Turn the adjusting screws (18) in a clockwise direction in small steps until the piece
of paper sticks slightly.
4. Check the setting by turning the cutting blade. None of the blades should be in con-
tact
5. Put the key (2) in its key holder (3) again.
If it is no longer possible to adjust the cutting clearance, the blades must be replaced
as a set. -
Blades are available from After Sales Support!
IX. TECHNICAL DATA
Blade width
380 mm
Cutting height
15 - 44 mm
Number of blades
5
Grass catcher capacity approx.
25 L
Weight approx.
8.5 kg
AUS
Cleaning/Maintenance/Technical data
Hand Push Mower 38cm
12
AFTER SALES SUPPORT
1300 855 831
MODEL: HAND PUSH MOWER 38CM PRODUCT CODE: 61621
10/2018
