14
Jack assembly
Attaching the carrying handle
On each side of the lifting lever socket
4
is a nut to which
the carrying handle
6
needs to be attached.
1. Place one of the carrying handle’s “eyes” over the carrying
handle nut
8
(see
Fig. C).
2. Carefully stretch and fi t the carrying handle’s other eye
into place. You may need to exert a bit of pressure on the
carrying handle’s eyes to push them properly into place.
The carrying handle should now sit snugly in place (see
Fig. A).
3. Before carrying the jack, make sure the carrying handle
fi ts snugly in place by pushing the jack back and forth. The
carrying handle should stay securely attached during this.
If it does not, re-attach the carrying handle.
Assembling the lifting lever
1. Align the 2 halves of the lifting lever
5
with the locking
pin
10
in one section with the drilled hole
11
in the other
section (see
Fig. B).
2. Push both pieces together until the locking pin “clicks”
(see
Fig. B).
To disassemble the lifting lever, remove the lifting
handle from the jack. Push down on the locking pin to
separate the two halves, then snap each half into place in
the lifting lever clips
9
on either side of the jack (see
Fig. A
and
B).
Jack assembly
