Alarm Systems
Control Panels
Float Switches
Leak Detection Systems
Page 2 of 2
PO Box 827 Hawley, MN 56549 (218) 483-3034 Fax (218) 483-3036 www.alderonind.com
Operation, Maintenance and Installation Manual
Part Number - 8059
Pump Station Alarm
Schematic Drawing for Wiring
There are two (2) different ways to wire the alarm panel depending on which type of application being used, either
Dry or Wet contacts from the main pump panel. The Pump Station Alarm Panel comes with a jumper wire installed
on Terminals 3 and 4 (Fig. 1 and Fig. 3). If using a Dry Alarm Contact from the main pump panel, see Figure 2.
Outdoor Remote Alarm Panel
(Fig. 1)
(Fig. 2)
(Fig. 3)
Panel Features
Alarm LED
Indicator
Alarm Silence
Pushbutton
(auto reset)
(Cover Removed)
Buzzer
Auxiliary
Contacts
Relay
Silence
Relay
Field Connection
Terminal Block
Specifications
Primary Power
120 VAC from Main Control Panel Signal or
Separate 120 VAC Feed
Input Signal
Dry Contacts Rated to 120 VAC,
1 Amp Minimum
Wet Contacts Rated to 120 VAC
Auxiliary Contacts
Normally Open - Dry
120 VAC, 5 Amps Maximum
Enclosure
Type 4X Thermoplastic, Padlockable
Alarm Indicator
120 VAC, Red LED, 22mm Diameter
Alarm Buzzer
95db @ 2-feet