AlcoMate AccuCell AL9000, Руководство оператора

Страница: 4 / 8

4
- Device Setup and Operation -
1. If batteries are not already installed, remove the rear cover of the device using the method described
on the previous page, then insert two 1.5V AAA batteries (included) into the battery slot.
2. Snap the rear cover back in place.
3. Press and hold the power button to see the current cumulative test count in the screen; releasing the
button begins the warm-up countdown.
4. Wait for the display to show "blow".
5. You are now ready to test. Please insert a mouthpiece into the mouthpieces slot.
6. Blow sharply into the device until you hear the first audible click and continue to steadily blow until
you hear the second audible click, which signals that sampling is complete. You should continue to blow
more than 3 seconds until you hear the second audible clicks.
7. After a successful sample, the device will analyze the sample for a few seconds (you will see the digit 0
move back-and-forth in the display).
8. Your reading will be displayed on the screen in g/dL ("%BAC"). While the result is being displayed, you
will see the "WAIT" indicator light on and also hear a short series of beeps.
9. The device will shut off automatically within 15 seconds, showing "Out" in the display.
- Warnings and Error Codes -
Warnings and Precautions

WAIT AT LEAST 20 MINUTES AFTER EATING OR DRINKING BEFORE TESTING. A breathalyzer
examines “lung air” samples, not “mouth air” to calculate alcohol content. Any “contaminants” in the
mouth, including alcohol, food, smoke, or even excess saliva, may interfere with testing. This
includes alcohol-based mouthwash or similar products.
This is the most common cause of improper
use and incorrect results.

Avoid testing in high wind or enclosed spaces. Poor ventilation may also lengthen the time required
for warm up between tests.

Do not blow smoke, saliva or other contaminants into the mouthpiece, as the sensor may become
damaged.

Do NOT use the AccuCell AL9000 as a tool to drink and drive.