Alcom Premium ADT1308, Инструкция по эксплуатации

Страница: 14 / 17

14
registered handset will displays
HS2
or
HS3
on the LCD according to the registration sequence.
3. Press key on base unit to locate the handsets.
OPERATION
Speakerphone operation & volume control
Press key once to obtain a dial tone, dial your number, when you hear the other party start your
conversation. You can also answer an incoming call by pressing the key once.
During the speakerphone operation, the user can adjust the speaker volume level by pressing the
▲
or
▼
key .Total 6 levels for selection.
If you press key to use earpiece, you can press the
▲
or
▼
key to adjust the earpiece volume, total 5
levels for selection.
Mute the MIC
During a call, press
MUTE
key once to mute the MIC and
MUTE
will show on LCD. Press
MUTE
key again to
get back to the call and the
MUTE
will disappear.
Caller ID – type I & II
¾ TYPE I
After you have applied the caller ID service, you can see the caller party phone number during an incoming
ring.
¾ TYPE II
During the conversation, the phone number of the incoming call of the second caller can be seen in the unit.
Note: Above caller ID services must be subscribed /supported by your telephone service provider.
Flash function
When a number is dialled and the line is busy, press
R/CLR
key and then press
RD/P
key to dial it out again or
enter a new number.
When on an external call, press
R/CLR
to access call waiting (2
nd
Call) when you hear the signal.
Press the key again to toggle between your two callers.
Note: Above call waiting services must be subscribed /supported by your telephone service provider.
Pause
Press
RD/P
key will insert a time delay of 3.6 seconds in a dialing sequence.
Pre-dialing
The unit has pre-dialing function, you may enter and edit the number before dialing out.
The following procedure describes how to use this function
:
1. In idle mode, enter the number you want to dial. For wrong entries you can press
R/CLR
key to correct the
number.
2. Press or key once, the unit will dial out the number show on the LCD.
Redial function