Page 10 of 11
G03711074
8-1-06
18
- ALL DOORS
19
- ALL DOORS
20
- ALL DOORS
Carefully caulk the interior jamb-to-wall
and curb-to-base joints. For appearance, you may
wish to caulk the exterior joints as well. We
recommend you wait twenty-four hours before the
first shower to allow the caulking to cure properly.
Cut four pieces of the larger vinyl [
GG
] 1/2"
longer than the horizontal opening and trim the
ends on a 45° angle. Install the top exterior vinyl
starting at both ends and working toward the
middle. Be careful not to stretch the vinyl.
Install the top interior vinyl and the two bottom
vinyls in the same way.
Cut four pieces of the smaller vinyl [
FF
] 1"
longer than the vertical opening (to prevent
gapping from shrinkage) and trim the ends on a
45° angle. Using the masking tape guides, center
the glass panel [
J
] in the frame. Cut four short (1"
- 2") pieces of the small vinyl and press into both
jambs on each side to hold the glass temporarily.
Take one of the long pieces of vinyl, and starting
on the outside exterior jamb, press each end into
the frame and work toward the middle. Be careful
not to stretch the vinyl. Install the other three
pieces in a similar fashion.
