1
AL-52859
RAISED TOILET SEAT INSTALLATION
AND OPERATION INSTRUCTIONS
PLEASE SAVE THESE INSTRUCTIONS FOR FUTURE USE
WARNING: Important! Read and understand these instructions before installing or using
the raised toilet seat. If you do not understand any part of these warnings, cautions or
instructions, contact a healthcare professional for direction in the use of this product. If the
raised toilet seat is not properly assembled and installed, personal injury and damage to the
raised toilet seat could result.
WARNING: If components are damaged or missing, contact your dealer immediately. DO NOT
use substitute parts.
WARNING: This product has a maximum weight capacity of 300 lb, EVENLY DISTRIBUTED.
WARNING:
ALCO Sales & Service Co.
assumes no responsibility for any damage or injury
caused by improper assembly, installation or use of this product.
INTENDED USE
The raised toilet seat is intended for use by those who have difficulty sitting down on or standing up from
the toilet.
INSTALLATION
Remove raised toilet seat, hardware, and protective packaging from carton.
Remove the hardware bag from inside the seat and shield assembly.
Splashguard models
only:
If the splashguard is not attached to the raised
toilet seat, perform the following steps to attach it
(tools required: Phillips
or blade screwdriver).
1. Remove hardware containing three screws from bag.
2. Align the three splashguard holes with the three holes on the bottom
of the toilet seat, as shown at right.
3. Use a Phillips or blade screwdriver to screw the splashguard to the
toilet seat with the provided screws. Start on one side and work your
way around to align the holes and install the screws.
All models:
See picture
at right of each model
with components
labeled. Each toilet seat
has four rim clamps (two
front and two rear) that
attach the toilet seat to
the toilet rim, and four
seat brackets (two front
and two rear), into which
the clamps screw, that
adjust seat height.
1.
clamps to toilet seat
rim and snap them on. If clamps are too loose, squeeze them closed slightly to ensure a tight fit.
2. Screw the two front rim clamps into the front seat brackets and adjust seat front to desired height.
For
stability, ensure that seat front is adjusted to the same height on both sides.
3. Align back rim clamps to toilet seat rim and snap them on.
U
nderside with splashguard
splashguard
screws
screw
locations
Align front rim
front rim clamps
front rim clamps
front rim clamps (locking)
rear rim clamp (locking)
wing nut
splashguard
rear rim clamp (locking)
wing nut
rear rim clamp
front seat brackets
front seat bracket
rear seat bracket
front seat brackets
rear seat bracket
