Mounting the Switch
Chassis and Power Supplies
page 2-12
OmniSwitch 8800 Hardware Users Guide
December 2004
Stand-Alone
The OmniSwitch 8800 can be installed unmounted as a stand-alone unit. Be sure that the installation loca-
tion is a stable, flat surface that can accommodate the
fully-populated
weight of all switches being
installed. One fully-populated OmniSwitch 8800 weighs approximately 220 pounds (100 kilograms).
Note.
OmniSwitch 8800 switches must be installed “right side up.” Never attempt to operate a switch
while it is lying on its side.
To install the switch as a stand-alone unit, follow the steps below:
1
Use two or more people to move and position the unpopulated chassis upright on the floor or bench
where it is to be installed.
2
Be sure that adequate clearance has been provided for chassis airflow and that you have placed the
chassis within reach of all required AC outlets. For recommended airflow allowances, refer to
Note.
For detailed information on installing additional components and connecting the switch, refer to the
OmniSwitch 8800 Getting Started Guide
.
