Alcatel omniaccess 4302, Руководство по установке

Страница: 14 / 32

Overview
Chapter 1
4 OmniAccess 4302 WLAN Switch 031986-00
Installation Guide February 2006
System Indicator LEDs
The system LEDs, located on the front of the switch, display the status of system
power and operation.
Fast Ethernet WAN Port
The Alcatel OmniAccess 4302 WLAN Switch provides one 10/100 Mbps Fast
Ethernet (FE) port to connect to a WAN link. The FE port automatically senses and
negotiates speed, duplex, and MDI/MDX settings.
From the WebUI and the CLI, this port address is interface fastethernet 1/0 .
The port has two LEDs above the port: a LNK/ACT LED on the left and a 100 LED
on the right. During operation, these LEDs provide the following information:
Use a Category 5 (or better) UTP cable with RJ-45 connectors to connect to
devices up to 100m (325 feet) away.
T
ABLE
1-1 System LEDs
LED State Description
Power Green WLAN Switch is powered on.
Off WLAN Switch is powered off.
Status Green WLAN Switch has booted and is functioning
properly.
Off WLAN Switch is booting, loading software, or has
failed.
N
OTE
: This LED remains off until you perform the
initial setup described in the
Alcatel Quick
Start Guide (included in the Accessory Kit).
Status Description
LNK/ACT LED
Off No Ethernet link on the port.
Green An Ethernet link has been established on the port, but no data is
currently being transmitted or received.
Flashing
Green The port is transmitting or receiving data. The flashing rate is
fixed and is not proportional to your network activity.
100 LED
Off The Ethernet link speed is 10 Mbps.
Green The Ethernet link speed is 100 Mbps.
1
2