
User Manual
8AL90399ENAAed01
84 /101
5.5.3.1
Remove the customization kit
A
B
C
1
Slide your fingernail along
the piece to detach it from
the phone.
This piece is clipped to the four
corners. We recommend starting
from the back of the desk phone.
Carefully insert a thin, non-sharp
object over the colored piece on
left side.
Press, then slide the
piece towards the bottom
of the device a few
millimeters with your
thumbs.
2
Pull perpendicular to the
desk phone along the entire
length of the piece. Be
careful not to break the
clips.
Gently lift the piece by pushing
forward (you will hear a small click
when the piece is removed).
Remove the piece by
lifting it.
Be careful not to break
the clips.
3
Insert the thin, non-sharp object on
the right side.
4
Gently lift the piece by pushing
forward (you will hear a small click
when the piece is removed).
5
Remove the piece by rotating it as
shown in the drawing.
5.5.3.2
Install the custization kit
A
B
C
1
Place each clip facing the
corresponding notches. Be
careful to place the piece in
the correct direction: the
logo must be on the right
hand side.
Insert the piece around the speaker
of the station.
Press as shown in the drawing to
clip the piece in the front (you
should hear a small click when the
clip is in its notch).
Place the piece by
respecting the notches.
2
Press perpendicular to the
desk phone all along the
piece. Press gently so as not
to force and break a clip.
Push the piece by slight rotation
until it is in its place.
Slide the piece to the top
of the hands a few
millimeters with your
thumbs.
3
Press as shown in the drawing to
clip the piece in the back (you
should hear a small click when the
clip is in its notch).