Batteries and chargers
24
7
7.3
Dual Chargers
The Dual Charger is a two-slot desktop charger.The Dual chargers are designed to charge the IP Touch WLAN and a spare
Battery Pack.
Place the handset face forward into the Dual Charger front slot. Place a spare Battery Pack in the rear slot, charging contacts
down. The front slot takes charging precedence. The Battery Pack in the rear slot will begin charging when the handset in the
front slot is fully charged or when the front slot is empty.
Indicator light
An LED on steady indicates that the spare battery is charging. A flashing LED indicates spare battery charging malfunction
(insert the spare battery again or change it). When the LED is off, this means that the charging of the spare battery has
terminated, that the compartment is empty or that the charger is not connected to the mains.
Charge Complete
When the IP Touch WLAN is fully charged, Charge Complete will display.
7.4
The Gang Charger - only on Mobile IP Touch 610 WLAN
The Gang Charger is designed to charge four Battery Packs simultaneously. Chargers operate in a 50
°
to 85
°
F (10
°
to 30
°
C)
environment. Do not expose them to freezing temperatures or direct sunlight.
The Gang Charger is shipped with the appropriate power supply for the site’s location. Place the Gang Charger on a flat,
horizontal surface. Plug the power supply into the Gang Charger and into an appropriate wall outlet.
Using the GC
Insert the Battery Pack into one of the four charging bays so that the Battery Pack contacts meet the charging bay contacts. The
LED above the charging bay will turn on to indicate that charging is in progress. When charging is complete the LED will turn
off. Lift the Battery Pack out of the charging bay.
Blinking LED
If the LED starts blinking as soon as the Battery Pack is inserted, the Battery Pack may be improperly seated. Lift it out and
reinsert. If the LED continues to blink or starts blinking at any time during the charging process, it indicates that there is a
problem with the Battery Pack that makes it unusable. Do not continue to charge the Battery Pack. Dispose of it properly and
do not attempt to use it in the IP Touch WLAN. Do not attempt to open or repair a defective Battery Pack. Contact your
service representative for assistance. If the LED is on steady, this means the charger is defective. Contact your administrator.
7.5
Cleaning the Chargers
Clean the Chargers by wiping the surface with a clean, water-dampened cloth or paper towel. A mild detergent solution may be
used. Be sure to wipe away any detergent residue with a plain water dampened cloth. DO NOT IMMERSE THE CHARGER IN
WATER OR OTHER LIQUID. DO NOT POUR LIQUIDS INTO THE SLOT.
The Battery Pack contacts on the IP Touch WLAN may be cleaned with isopropyl (rubbing) alcohol applied with a Q-tip, cloth,
or paper towel. Do not push or pull the exposed Battery Pack contacts.
•
Important information
•
Never use non-IP Touch WLAN charging units as they could damage the Battery Pack.
•
Only use the original plug-in power adapter for the Chargers.
•
Do not immerse the Battery Pack in water or throw into the fire.
•
Do not throw away the Battery Pack with your domestic waste. Take used Battery Packs to an appropriate collection point for
recycling or send them back to your supplier or servicing agent.
•
Replacement Battery Packs are available from your supplier or servicing agent.
Содержание IP Touch WLAN Handset 310
Страница 2: ......
Страница 4: ...How ...
