Alcatel-Lucent 7450 ESS Series, Руководство по настройке

Страница: 62 / 540

Page 62 7450 ESS OS Router Configuration Guide
Common Configuration Tasks
The following sections describe basic system tasks.
• Configuring a System Name on page 62
• Configuring Interfaces on page 63

Configuring a System Interface on page 63

Configuring a Network Interface on page 63
• Configuring Proxy ARP on page 67
• Creating an IP Address Range on page 70
• Configuring an Autonomous System on page 76
• Configuring Overload State on a Single SFM on page 77
Configuring a System Name
Use the
system
command to configure a name for the device. The name is used in the prompt
string. Only one system name can be configured. If multiple system names are configured, the last
one configured will overwrite the previous entry.
If special characters are included in the system name string, such as spaces, #, or ?, the entire string
must be enclosed in double quotes. Use the following CLI syntax to configure the system name:
CLI Syntax:
config# system
name system-name
Example :
config# system
config>system# name ALA-A
ALA-A>config>system# exit all
ALA-A#
The following example displays the system name output.
A:ALA-A>config>system# info
#------------------------------------------
# System Configuration
#------------------------------------------
name "ALA-A"
location "Mt.View, CA, NE corner of FERG 1 Building"
coordinates "37.390, -122.05500 degrees lat."
snmp
exit
. . .
exit