Alcatel-Lucent 7450 ESS Series, Руководство по настройке

Страница: 129 / 540

IP Router Configuration
7450 ESS OS Router Configuration Guide Page 129
If the user changes the cost of an interface, the new value is advertised at the next flooding of link
attributes by IGP. However, if the LDP synchronization timer is still running, the new cost value will
only be advertised after the timer expired. Also, the new cost value will be advertised after the user
executes any of the following commands if the currently advertised cost is different:
• tools>perform>router>isis>ldp-sync-exit
• tools>perform>router>ospf>ldp-sync-exit
• config>router>interface>no ldp-sync-timer
• config>router>ospf>disable-ldp-sync
• router>isis>disable-ldp-sync
If the user changes the value of the LDP synchronization timer parameter, the new value will take
effect at the next synchronization event. In other words, if the timer is still running, it will continue
using the previous value.
If parallel links exist to the same neighbor, then the bindings and services should remain UP as long
as there is one interface that is UP. However, the user configured LDP synchronization timer still
applies on the failed then restored interface. In this case, the router will only consider this interface
for forwarding after IGP re-advertized its actual cost value.
Note that the LDP Sync Timer State is not always synched across to the standby CPM, so after an
activity switch the timer state might not be same as it was on the previous active CPM.
The no form of this command disables IGP/LDP synchronization and deletes the configuration
Default
no ldp-sync-timer
Parameters seconds — Specifies the time interval for the IGP-LDP synchronization timer in seconds.
Values 1 – 1800
loopback
Syntax [ no ] loopback
Context config>router>interface
Description
This command configures the interface as a loopback interface.
Default Not enabled
lsr-load-balancing
Syntax lsr-load-balancing hashing-algorithm
no lsr-load-balancing
Context config>router>if
Description This command specifies whether the IP header is used in the LAG and ECMP LSR hashing
algorithm. This is the per interface setting.