Alcatel-Lucent 7450 ESS-1, Руководство по установке

Страница: 64 / 92

Initial System Startup
Page 64 7450 ESS-1
Initial System Startup
To initialize the system, follow these steps:
Step 1
When the compact flash card is installed in the slot, the Compact Flash 3 LED (located
on the front panel) should light green within approximately 30 seconds. If it does not light
or if it turns off again, refer to
Troubleshooting .
Step 2
Depress the Reset button or power cycle the switch to initiate the boot process.
Step 3
The system searches Compact Flash Slot #3 ( cf3 ) for the
boot.ldr
file (also known as
the bootstrap file).
Step 4
Verify the operational status by checking the Power and Status LEDs on the SF/CPM
faceplate. If the LEDs on the front panel blink continuously, refer to
Troubleshooting .
Step 5
After verifying the LEDs, proceed with the MDA installation and configurations.
Troubleshooting
If the system cannot load or cannot find the
boot.ldr
file on cf3 , the system checks for a manual
boot sequence interruption. Unless an unsuccessful system initialization is manually interrupted,
the system will continuously reboot in an attempt to successfully find and load the
boot.ldr
file.
When the system finds the
boot.ldr
file, the system processes the initialization parameters from
the BOF. The BOF should be on the same drive as the boot loader file. If the
BOF
cannot be found
or loaded, then the system prompts for a different image and configuration location.
When the image is successfully loaded, control is passed from the boot loader file to the image.
The runtime image attempts to locate the configuration file as configured in the BOF. The
configuration file include chassis, IOM, MDA, and port configurations, as well as system, routing,
and service configurations.