QUICK PROGRAMMING GUIDE
912-US
Output channel
B/G CCIR C21
Input frequency
1325 MHz
Scan
->->->
Audio frequency
5.80 MHz
Bandwidth IF
27 MHz
Video polarity
(Ku/C Band): +
Video deviation
25 MHz/Vpp
-= PS-003 =-
v: 1.0
Serie 912
US
Bandwidth of
audio: 280 KHz
Deemphasis of
audio: J17
Mode:
TV
Table channels
B/G CCIR
Audio level
ENG
Press any key to turn on the PS-003.
Select the series to program: 912-US.
With the arrows, select the video polarity used by the
transponder to receive from the satellite.
Select the video deviation using the arrows.
Select the bandwidth of the transponder which is being
programmed. Then press
T
to transmit.
Set the programming switch of the US module to the ON position.
The programming indicator will immediately light up.
Set the programming switch of the US module to the OFF position.
The programming indicator will immediately go out.
Enter the input IF (intermediate frequency) of the US module
using the arrows or the digital keypad. Then press
T
to
transmit or...
Select the frequency of the audio carrier in the selected
transponder. Then press
T
to transmit.
Select the table of channels in accordance with the standard
of the country in which the equipment is being used.
Enter the output channel of the US module using the arrows
or the digital keypad. Then press
T
to transmit.
Adjust the audio level at the output of the module using
the arrows.
Select the bandwidth of the audio carrier. Then press
T
to transmit.
Select the de-emphasis to balance the audio. Then press
T
to transmit.
Select the mode of the transmodulated channel: TV or
Radio. Then press
T
to transmit.
... select the direction for searching for channels (ascending
or descending frequency) using the arrows. Then press
T
to start the search; continue pressing
T
until you find
the desired program.
Note 1
: You can send all the data to the module, except the output channel, in a single go by pressing
F
+
COPY
.