— 9 —
— 8 —
INSTALLATION
Installing the Camera(s)
u
If not mounting, but just using on a flat
surface (desk, table, etc.), skip to step 4.
v
Secure the multi-position camera bracket
to a stable surface, ceiling or wall using
the three screws. If needed, three
anchors are also included.
w
Loosen the T-Bolt on the Camera Bracket
and adjust viewing angle using the
Thumb Screw to rotate position.
x
BOTTOM/SURFACE MOUNT:
u
Align Mounting socket on bottom of
camera with T-Bolt and screw camera
onto the T-Bolt until it is in the desired
position.
v
Tighten the Brace against the camera to
secure it in place.
w
Set the desired camera angle and then
tighten the Thumb Screw.
CEILING MOUNT:
u
Remove the screw on the camera cover,
then align Mounting socket on top of
camera with T-Bolt and screw camera
onto it until it is in the desired position.
v
Tighten the Brace against the camera to
secure it in place.
w
Set the desired camera angle and then
tighten the Thumb Screw.
T-Bolt
Thumb
Screw
T-Bolt
Thumb
Screw
u
v
w
u
v
w
INSTALLATION
Installing the Camera(s)
y
Screw Antenna clockwise into rear of
camera.
U
Connect one end of an AC adapter to
the camera’s power pigtail and plug the
other end of the adapter to a 120 volt AC
(standard indoor) power outlet.
This camera works with the AWS3266
base station, which should be turned on
to connect the camera.
V
Make sure the Power status LED turns
red and the Link Status LED turns green.
If it doesn’t, try reconnecting the AC
adapter, and make sure the power outlet
is not controlled by a wall switch.
You should now have video on your Live
screen.
Repeat steps for additional camera(s).
Power Status
LED
Link Status
LED
TIP:
Pair camera as shown on the next page.
TIP:
A 6 foot power extension cable is included for
your camera setup if needed.
