In the scan
Programmed frequencies are the
Avoid programming frequencies
mode, the
same as birdie frequencies.
listed under „Birdie Frequencies“
scanner locks
on Page ?? or only listen to them
on frequencies
manually.
that have an
unclear trans-
mission.
-------------------------------------------------------------------------------------------------------------------------
GENERAL RESET / INITIALIZING THE SCANNER
If the scanner’s display locks up or does not work properly after you connect a power source, you might
need to reset or initialize it.
Important: If you have problems, first try to reset the scanner. If that does not work, you can initialize the
scanner, however, initializing clears all frequencies you stored in the scanner’s memory and initialilzes
the scanner to its default settings.
Resetting the Scanner
1. Turn off the scanner, then turn it on again.
2. Insert a pointed object, such as a straightened paper clip, into the reset hole on the side of the
scanner. Then gently press and release the reset button inside the opening. The display goes blank,
then information reappears.
Initializing the Scanner
Important: This procedure clears all frequencies you stored in the scanner’s memory and initializes the
scanner to its default settings. Initialize the scanner only when you are sure the scanner is not working
properly.
1. Turn off the scanner, then turn it on again.
2. While holding down CLEAR, insert a pointed object, such as a straightened paper clip, into the reset
hole on the side of the scanner. Then gently press and release the reset button inside the opening. The
display goes blank, then information reappears.
Note: You must release the reset button before you release CLEAR. Otherwise, the memory might not
clear.
3. When the display reappears, release CLEAR.
CARE AND MAINTENANCE
The following suggestions will help you care for your scanner so you can enjoy it for years.
Keep the scanner dry. If it gets wet, wipe it dry immediately.
Use only fresh batteries of the required size and type. Always remove old and weak batteries. They can
leak chemicals that destroy electronic circuits.
Handle the scanner gently and carefully. Dropping it can damage circuit boards and cases and can
cause the scanner to work improperly.
