Albrecht AE 6190 HD -X, Руководство по эксплуатации, Страница: 11 / 16

11
11
made, agree on a free channel for your conversation and then channel 9 will be free
again for other calls.
An emergency channel can of course only work if as many stations as possible are
listening in. Therefore listen in to this channel as often as possible!
Channel 16 Water sport channel
Channel 19 Trucker channel on AM in France, Spain and Italy
Channel 24/25 Data transfer (Packet Radio, Germany only)
Channel 40 Calling channel in Switzerland
Some recommendations have been worked out by the CB clubs for the German
channels 41 to 80. To find out which channels are suitable for special purposes,
please get in touch with the respective groups or check in CB magazines.
Direct channel access key CH9
Your transceiver has an extra button on the microphone which provides direct access
to the most important channels 9 described in previous chapter.
You can toggle with the button between “normal” channel selected previously, CH 9
and back again. Just press the button consequently.
Scan mode
Your AE 6190 HD-X has an automatic channel scan, which can be used to observe
all channels consequently.
First choose the mode (AM or FM). Adjust the muting control to the point at which the
receiver should open (see also ‘Adjusting squelch’).
Start channel scan
•
Briefly press the button SC
•
Scan starts almost immediately by scanning all the channels upwards
•
Scanning is stopped at each signal worth receiving and you can listen in to the
conversation.
If you leave the set alone it will re-start a) after the communication on the channels
has stopped or b) after about 5 seconds observation time, if the communication
should last longer.
Stop channel scan
•
You can stop the scan at any time by pressing the SC button a second time.
•
Pressing the transmission button will also automatically stop the scan modus.
Transmitting and correct use of microphone
With the transmission button ( P ush T o T alk) on the side of the microphone you can
switch between receiving and transmitting:
•
Press PTT button to transmit.
Your radio is equipped with a TX control LED, this will light when you are
transmitting on an allowed channel in an allowed mode.
•
Release PTT button again to switch back to receiving.