Albatron PX915G Series, Руководство пользователя

Страница: 37 / 54

PX915P/ PX915G Series
33
IDE channel0 /channel1 /Master / Slave UDMA
Ultra DMA 100 functionality can be implemented if it is supported by the IDE hard drives
in your system. As well, your operating environment requires a DMA driver (Windows 95
OSR2 or a third party IDE bus master driver). If your hard drive and your system software
both support Ultra DMA 100, select “Auto” to enable BIOS support.
Options: Auto (default)
、
Disabled
***OnChip Serial ATA Setting***
On-Chip Serial ATA
This field allows you to select the on-chip Serial ATA operating mode which will
determine how you will use your Serial ATA drives with the other standard IDE drives.
This system can physically attach 2 IDE drives and 4 SATA drives but will have certain
limitations as described below.
Options
：
Disabled Disable on-chip serial ATA. No Serial ATA devices installed.
Auto(default) BIOS will auto-detect the presence of any SATA devices.
2 (or 1) IDE d 4 (or 3) SATA drivers Enhanced Mode
2 (or 1) IDE d 2 (or 1) SATA drivers (Must connect with SATA1
+3 or with SATA2+4) Combined Mode
4 ( or 3 or 2 or 1)SATA drivers SATA only
2 (or 1) IDE drivers Disabled
Combined Mode Windows ® 98/ME can recognize IDE devices but cannot directly
recognize an SATA device and therefore you must use this mode to
allow the SATA device to simulate an IDE device by assuming the
role of one IDE channel in the system. This means that you will have
one available IDE channel for 2 SATA drives to use (each IDE channel
can support 2 IDE drives). If you were to install all both IDE drives
and 4 SATA drives, you will only see 2 of the SATA drives along with
the 2 IDE drives.
Enhanced Mode In this mode, you can use all 6 hard disk drives (including 2 IDE drives
and 4 SATA drives). Note: You cannot use “Enhanced” mode with
Windows® 98/ME. It only support to install Windows® 2000/ XP if you
want to boot from SATA device. (It’s restriction from Microsoft.)
SATA Only Select this option when you install SATA drives only.
PATA IDE Mode
This item allows you to select an IDE channel for PATA IDE devices. When you install the
SATA device(s) to the SATA1 or 3 or 1+3, this item should be set to channel 1. When you
install the device(s) to the SATA2 or 4 or 2+4, this item should be set to channel 0.
Options: Channel 0 (default)
、
channel 1
SATA Port
This item will display which IDE channel will be used to the SATA device.
Options: SATA2, 4 is channel 1