PX848 Like Series
31
Hot Key Power ON
This option allows you to use the Ctrl key along with a hot key (function key) to power on your
system. This filed is only configurable when “Power On Function” is set to “Hot Key”.
Options: Ctrl-F1
、
Ctrl-F2…… Ctrl-F12
Onboard FDC Controller
Select “Enabled” if your system has a floppy disk controller (FDC) installed on the system board and
you wish to use it. If you install an add-in FDC or the system has no floppy drive, select “Disabled”.
Options: Enabled (default)
、
Disabled
Onboard Serial Port 1/ Port 2
Select an address and corresponding interrupt for the first/ second serial port.
Options: Disabled
、
3F8/IRQ4 (default for port1)
、
2F8/IRQ3(default for port2)
、
3E8/IRQ4
、
2E8/IRQ3
、
Auto
UART Mode Select
This item allows you to select the Infra Red (IR) standard to be used.
Options: Normal (default)
、
ASKIR
、
IrDA
RxD, TxD Active
This item determines the RxD and TxD frequencies. This field only configurable if “UART Mode
Select” is set to “ASKIR” or “IrDA”. Options: Hi / Lo (default)
、
Hi / Hi
、
Lo / Hi
、
Lo / Lo
IR Transmission Delay
This item allows you to enable/disable IR transmission delay. This field only configurable if “UART
Mode Select” is set to “ASKIR” or “IrDA”.
Options: Enabled (default)
、
Disabled
UR2 Duplex Mode
Select the transmission mode used by the IR interface. Full-duplex mode permits simultaneous
bi-directional transmission. Half-duplex mode permits transmission in only one direction at a time.
This field only configurable if “UART Mode Select” is set to “ASKIR” or “IrDA”.
Options: Half (default)
、
Full
Onboard Parallel Port
Select an address and corresponding interrupt for the onboard parallel port.
Options: 378/IRQ7 (default)
、
278/IRQ5
、
3BC/IRQ7
、
Disabled
