Page 4
Battery installation
Follow the below steps to install 4 x AA batteries .
1:
Un clip the battery cover in the direction indicated on
the cover .
2:
Insert
4
x
AA
batteries in the sequence shown,
observing polarity . The correct direction each battery
needs to be installed is indicated inside the battery
compartment .
3:
Refit the battery cover
NOTE: To run the radio on battery power you will
need to switch off and disconnect the mains cable
if connected.
Mains power
To run the radio from mains power follow the below
instructions .
1:
Connect the
DC
mains plug to the
DC
mains input
socket
(9)
on the rear of the unit .
2:
Connect the plug to a mains outlet and switch on .
Standby & power off mode
1:
Press and hold the
POWER/MODE
button
(1)
for
1
second to put the system into standby mode . The
date and time are displayed during standby .
2:
When in standby mode press and hold the
POWER/
MODE
button
(1)
for
1
second again to enter power off
mode . You can use this mode to save battery power or
when not using the unit for a long time .
3:
To resume normal operation press the
POWER/MODE
button
(1)
.
NOTE:
This unit is designed to enter
STANDBY
mode
automatically after
15
MINUTES (approximately)
if
no stations are located . Press the
STANDBY
button to
wake the unit .
Getting started
1:
Extend the telescopic antenna
2:
Press the
POWER/MODE
button
(1)
to switch the unit
on from
STANDBY
mode .
3:
After switching the unit
ON
, you will see
‘Welcome to
Digital Radio’
on the display and then a
FULL SCAN
will be performed .
Welcome to
Digital Radio
Scanning... 34
During the full scan mode, the LCD will display a slide
bar that indicates the progress of the scan, and the
amount of radio stations that have been found so far.
Once the scan has finished, the radio will select the
first alphanumeric station.
NOTE: The station name will be shown on the top
of the display. Information about the DAB radio
station will be displayed on the bottom of the
display.
Volume
1:
Rotate the
VOLUME/SELECT
control
(6)
clockwise to
increase the volume level .
2:
Rotate the
VOLUME/SELECT
control
(6)
anti-
clockwise to decrease the volume level .
DAB operation
Press the POWER/MODE button (6) (if in FM mode) to
switch to DAB mode. The display will show ‘DAB’.
1:
To listen to the stored
DAB
stations use either
PREV
(3)
or
NEXT (8)
buttons to cycle through the stations .
When you reach the desired station press the
VOLUME/SELECT
control
(2)
in to begin playback of
that station .
NOTE: If when the unit was switched on, no
stations where found, or no DAB stations can
be received currently [No DAB station] will be
displayed. See the quick or full scan sections.
Installation
