Alba 211009, Инструкция по эксплуатации

Страница: 28 / 32

Product support
Help is always at hand
Product support
28
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
Troubleshooting
CD does not play
• Check that you are in CD mode. If you are not already in CD mode, slide the switch
on the back of the Boombox to CD/Aux in.
• If you have an audio cable plugged into the Line in socket on the Boombox, you
must unplug this before you can use the CD player. After unplugging the audio
cable, please wait for approximately 15 seconds for the Boombox to return to CD
mode.
• Take out the CD and check that it is not marked or scratched. Damaged CDs
cannot be played in the Boombox or may skip or not rotate correctly in the CD
compartment.
• Please check that you are using an original audio CD and not a copy. Often copied
CDs will not play.
The function buttons do not respond.
• Check that mains power wall socket is switched on.
• Slide the switch on the back of the Boombox to the mode you would like to use. The
red power LED to the left of the display will switch on.
• Check that you are trying to use the function buttons for the mode that you are in.
• If you are using batteries, they may be exhausted and need to be replaced.
• If you are using mains power, unplug the mains power. Leave the Boombox for 3
minutes and then reconnect the power.
Radio reception is poor.
• Check that you have extended the wire radio aerial in a vertical position. .
• Move the tuning wheel slowly to tune to each radio station.
• Check there are no other electrical appliances within 1 metre of your Boombox,
which may be causing interference.
• Try moving your Boombox to another location.