Alaxala AX3630S, Руководство пользователя программного обеспечения

Страница: 869 / 875

40. Error Messages Displayed When Editing the Configuration
841
40.1.27 sFlow statistics
Table 40-27: sFlow statistics error messages
40.1.28 OADP information
Table 40-28: OADP error messages
<group name> : Indicates the group name.
Informs is supported by only SNMPv2C. The inform function is supported by SNMPv2C.
Select SNMPv2C to use the inform function.
Invalid oid-tree. <oid tree> The value for <oid tree> is invalid.
For <oid tree> , specify an object identifier in dot notation.
<oid tree> : Indicates subtree information.
MIB view exceeded 50 entries. <view name> The number of MIB view entries exceeded 50.
Delete unnecessary MIB view entries, and then add the new one.
<view name> : Indicates the MIB view name.
RMON alarm rising threshold is less than
falling threshold.
The upper threshold value is less than the lower threshold value.
The upper threshold value must be equal to or larger than the lower
threshold value.
Subtree of the same MIB view exceeded 30
entries. <view name> <oid tree>
The number of subtrees in one MIB view exceeded 30.
Delete unnecessary subtrees, and then add the new one.
<view name> : Indicates the MIB view name.
<oid tree> : Indicates subtree information.
Message Description
Maximum number of entries are already defined. The number of collectors that have been set exceeds the maximum.
The number of collectors that have been set must not exceed four.
Only either of the following commands "sflow
forward egress" or "sflow forward ingress" can
be configured at a time on this device.
You can specify either
sflow forward egress
or
sflow forward
ingress
for the switch.
To specify the sent traffic as the monitoring target, delete any
sflow
forward ingress
specifications for other ports, and then set the
command for the port to be monitored.
To specify the received traffic as the monitoring target, delete any
sflow forward egress
specifications for other ports, and then set
the command for the port to be monitored.
This system doesn't support "sflow forward
egress" the command.
The
sflow forward egress
command cannot be used because it is
not supported by the Switch.
Message Description
Invalid parameter, hold-time must be longer
than interval-time.
The value set by the
oadp interval-time
command is inconsistent with
that set by the
oadp hold-time
command.
• If this message is output when setting
oadp interval-time
The value set by this command is larger than the value set by the
oadp
hold-time
command.
•
If this message is output when setting
oadp hold-time
The value set by this command is smaller than the value set by the
oadp
interval-time
command.
Message Description