background image

2PF290082100001

2018/07  V0

• Model: SC003
• Dimension: L35×W35.4×D8.25mm
• Weight: 4.9g
• Accuracy: +/- 2 %
• Detected Speed range: 24 ~780 rpm( approx.3 ~98kph)
• Detected Cadence range: 10~240 rpm
• Operating temperature: -10~60°C (14~140°F)
• Wireless transmission interface: Bluetooth 4.0 / ANT+
• Wireless transmission frequency: 2.402~2.480 GHz
• Battery: CR2032
• Battery life: approx.300 Hours

SPECIFICATIONS

      Note

If the sensor is installed on the crank, it will be automatically set to the 

cadence sensor. If installed on the wheel hub, it is automatically set to the 

speed sensor.
Continuously rotating for 5 seconds or more, the sensor’s LED will flash once 

to let you know that it's woken up.
The LED will flash red when the sensor is used to detect the cadence, and 

the LED flashes green when the sensor is used as the detection speed.
Flashes every 3 seconds during the detection period, and flashes every 5 

seconds if there is a Bluetooth connection. After 100 consecutive flashes, the 

LEDs automatically turns off to save battery power.
For the first time installation and use, please pair the sensor with your device.

1

2

3

4

5

!

FCC

Federal Communications Commission Statement

This device complies with FCC Rules Part 15. Operation is subject to the following 

two conditions:

• This device may not cause harmful interference.

• This device must accept any interference received, including interference that 

may cause undesired operation.

This equipment has been tested and found to comply with the limits for a class B 

digital device, pursuant to Part 15 of the Federal Communications Commission 

(FCC) rules. These limits are designed to provide reasonable protection against 

harmful interference in a residential installation. This equipment generates, uses, 

and can radiate radio frequency energy and, if not installed and used in 

accordance with the instructions, may cause harmful interference to radio 

communications. However, there is no guarantee that interference will not occur in 

a particular installation. If this equipment causes harmful interference to radio or 

television reception, which can be determined by turning the equipment off and 

on, the user is encouraged to try to correct the interference by doing one or more 

of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the 

receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

FCC Caution

Any changes or modifications not expressly approved by the party responsible for 

compliance could void the user‘s authority to operate the equipment.

The antenna(s) used for this transmitter must not be co-located or operating in 

conjunction with any other antenna or transmitter.

MPE

This equipment must be installed and operated in accordance with provided 

instructions and the antenna(s) used for this transmitter must be installed to 

provide a separation distance of at least 20 cm from all persons.

Отзывы: